Electrician MarketerMarketing for electrical contractors
Guide

Advertising an electrical business without waste

Most electrical ad waste comes from four settings: match type, geography, hours and tracking, and all four are fixable before the budget grows.

By Ali Sedighi3 minute readReviewed November 2026

An electrical ad account rarely fails because the budget is too small. It fails because the money goes to searches that will never become jobs. The waste is boring and predictable: broad terms, a radius drawn with a circle, a campaign that runs when nobody answers, and no call tracking to prove any of it. This guide covers the order to fix those four things, so that the next dollar buys a call from someone with a panel problem. Fixing them costs time, not media. Order matters more than budget.

Start with the search terms. An electrical account should buy service calls, panel upgrades, charger installs, generator installs and commercial work, and it should refuse everything else. Add the negative list before launch: salary, jobs, apprenticeship, how to, DIY, wire a switch, breaker keeps tripping, multimeter, schematic. Those searches look electrical and convert at nothing. A tight keyword list with twenty terms beats a broad list with two hundred, and it is easier to read at the end of the month. Match types stay exact or phrase until the account has enough conversion data to justify anything wider, and that is usually several months away. Read the search term report weekly for the first two months. Keep the cut list.

Geography is the second leak. A radius drawn around a shop in Surrey can reach Abbotsford, Delta and three bridges worth of traffic the crew will not cross. Build the area from the postal codes and cities actually served, and set separate budgets for the dense core and the edges. Hours are the third: emergency campaigns run twenty-four hours only if the phone is answered twenty-four hours. Planned work can run business hours with a lower bid. Then watch the answering rate, because a missed call is the most expensive click in the account. Two addresses within one postal code can behave differently, so review the report by city, not by radius. Set bids by city, not by radius.

Tracking is the fourth, and it is the one that makes the other three fixable. A separate number per campaign, forwarded to the office phone, shows which clicks became conversations. Call recordings, where the law allows and the caller is told, show whether the office asked for the job. With that in place, the monthly job is simple: cut the terms with calls but no jobs, move the budget to the terms with jobs, and raise the bid only where the crew has capacity. Media stays at cost on the invoice, so the management fee never hides spend. A written monthly summary of calls, jobs and cost per job closes the loop. No dashboard needed. The invoice tells the story.

Checklist

  • The negative keyword list is built before launch
  • Match types start exact or phrase
  • The service area is built from served cities, not a radius
  • Campaign hours match the hours the phone is answered
  • Every campaign has its own tracked number

Print it or send it to the person who answers the phone.

Questions this raises

How much should an electrician spend on ads each month?

There is no universal figure. Management is published at $1,900, $2,800 or $4,400 a month with media at cost, so the media budget is set separately. Start from what one sold job is worth and cap the spend at a number you can measure.

How long before an ad campaign is judged?

Give it four to six weeks and enough calls to read. Judging on a handful of clicks produces noise. Keep a weekly search term review early, then judge on calls, sold jobs and cost per sold job.

Written and reviewed by Ali Sedighi. Published prices, a written scope and one monthly readout. Consulting by Sedighi.ca.

Tell us what the calendar should look like next quarter.

Call (604) 632-4959TextEmail
CallTextEmail
^